Regarding Flood-BAS ( ), it is actually a building automation system that can continue to work or protect itself when water disasters like floods occur. Do you know? There are not often unexpected heavy rainstorms in many places now. It is easy to cause floods when it rains, which has a great impact on the equipment in those buildings! So this Flood-BAS system is particularly useful for those who are easily flooded, and it is really necessary to install one!
1. The cleverness of the system composition : there are many different parts in it, not a single thing. It's like a water-sensitive sensor. This sensor can feel whether the water has risen or whether the environmental humidity has suddenly become high. There is also a waterproof controller. The shell outside the controller has a very good workmanship. It is a special material that is tightly sealed and cannot be entered at all. In terms of (actuators), it will also be installed in a slightly higher place in advance, or cover it with a waterproof cover to avoid being soaked directly by water. The final communication module is even more powerful. It will switch to that wireless way of communication, without fear of the line being soaked.
Provide global procurement services for weak current intelligent products! .
2. Small details to pay attention to when installing : When choosing a device, the protection level of main (main components) must be very, very high, at least IP67 or above, and it is best to reach IP68, so that it can be safe; the installation of the equipment must also be carefully selected, and it must not be installed in low-lying areas that have been flooded in history, and it must be installed at a higher level; when wiring, those (cables) must be used with shielding and waterproof wire (wires) and the joints must be handled with special waterproof terminals, and no gap can be left.
3. Important steps for daily maintenance : Every month, people have to arrange people to check whether the sensors can still work normally. Don’t call the alarm if they are really wet, which will be a big trouble; every six months, the shells of those controllers must be opened (of course, when the power is off, safety is the first priority!) to see if there is any moisture or dust in it. If so, clean it up quickly; every year, a comprehensive, simulated flood conditions test is carried out to see if the entire system responds quickly and accurately, and if there are any steps that have been forgotten or have problems.
Q: So is the price difference between this Flood-BAS and the ordinary BAS?
Answer: It must be more expensive than ordinary ones. After all, it uses a lot of materials and other materials (special), and the workmanship is more complicated! However, it is very cost-effective in the long run. If the flood really breaks the ordinary BAS, it will be both costly and time-consuming to repair. The losses caused by the failure to start the work for a long time are even greater, so this money still has to be spent!
Q: After installation, do you no longer have to worry about floods breaking the equipment?
Answer: It cannot be said so absolutely. Although it is very powerful and can greatly reduce the flooded risk, if you really encounter a super invincible flood that is rare in a century, and the water level is so high that it breaks through the upper limit setting, it may still be a little problem. But under normal circumstances, it can (cope with) floods, and the protection effect is already very, very good!
I personally think that those (commercial buildings) built by rivers, lakes, or cities with relatively low altitudes should consider installing this Flood-BAS system as soon as possible. Climate change is so uncertain now that you can prevent it in advance and have no worries. This is indeed the case… I’ll give my own building insurance, how safe it is!
Leave a Reply